Optional: Assigning a virtual IP address to a resource pool
The zentrap and zensyslog services are designed to receive data from devices in your environment at a specific IP address. Typically, the address is assigned to a specific host. However, if the host fails, then no data is received. To avoid this issue, you can assign a virtual IP address to a resource pool, and then Control Center can create a virtual IP interface on any host in the pool. Zenoss recommends using a virtual IP with resource pools that include Zenoss Core collection services as a best practice.
To perform this procedure, you need an unused IPv4 address in the same subnet as the other hosts in the resource pool to modify. To avoid conflicts, ask your networking specialist to assign or reserve the address. In addition, all of the hosts in the resource pool to modify must have the same network interface names.
- Log in to the Control Center browser interface.
- At the top of the page, click Resource Pools.
- In the Resource Pool column of the Resource Pools table, click the name of the resource pool to modify.
- At the right side of the Virtual IPs table, click Add Virtual IP.
In the Add Virtual IP dialog, specify the virtual IP.
In the IP field, enter an IPv4 address.
The address must be in the same subnet as the other hosts in the current resource pool.
In the Netmask field, enter an IPv4 subnet mask.
The mask must match the range of addresses in the current resource pool. The following table associates commonly-used subnet masks with the number of addresses they include.
Subnet mask Addresses in subnet 255.255.255.192 64 255.255.255.224 32 255.255.255.240 16 255.255.255.248 8
- In the Interface field, enter the name of the network interface that is used on all hosts in the resource pool.
- At the bottom of the Add Virtual IP dialog, click Add Virtual IP.
- In the IP field, enter an IPv4 address.